Initiate Commands - Keithley 7001 Instruction Manual

:INITiate commands

5.18.1
[:IMMediate]
:INITiate[:IMMediate]
Short-form
:init
format
This command takes the Model 7001 out of the idle state. After the completion of a scan, the
Description
instrument will return to the idle state (if continuous initiation is disabled; see next command).
This is an overlapped command (see *OPC, *OPC?, *TRG and *WAI).`
Programming
OUTPUT 707; ":init"
example
:CONTinuous <b>
:INITiate:CONTinuous <b>
Parameters
<b>
Short-form
:init:cont <b>
format
Power-up
Defaults
*RST
:SYSTem:PRESet
Artisan Scientific - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisan-scientific.com
Trigger subsystem
Front panel operation and IEEE-488 operation use different nomencalture for
the three layers of the Trigger Model and is summarized as follows:
Trigger Model Layer Nomenclature
Layer Name; Front
Layer Panel Operation
First layer Arm Layer
Second layer Scan Layer
Third layer Channel Layer
! Takes 7001 out of the idle state.
= 0 or OFF Disable continuous initiation
= 1 or ON Enable continuous initiation
Saved power-on setup
OFF
ON
NOTE
Layer Name; IEEE-488
Bus Operation
Arm Layer 1
Arm Layer 2
Trigger Layer
Take 7001 out of idle
Control continuous initiation
IEEE-488 Reference
5-123