Table of Contents
Advertisement
IEEE-488 Reference
Description
Programming
example
5.13.8
Parameters
Short-form
formats
Defaults
5-84
Artisan Scientific - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisan-scientific.com
[:ROUTe] subsystem
With Card Pair enabled, the corresponding channels of the two slots are controlled concurrently.
For example, when channel 5 of CARD 1 (Slot 1) is closed, channel 5 of CARD 2 (Slot 2) is
also closed.
Card Pair can only be enabled for similar type cards. For example, you will not be able to enable
Card pair if a multiplexer card is installed in Slot 1 and a matrix card is installed in Slot 0.
If enabling Card Pair adds a restricted channel to the Scan List and/or a Channel Pattern, then
the entire Scan List and/or Channel Pattern is cleared (lost).
10
OUTPUT 707; ":conf:cpa on; cpa?"
20
ENTER 707; A$
30
PRINT A$
40
END
Line 10 Enables Card Pair and then queries its status.
Line 20 Addresses the 7001 to talk.
Line 30 Displays the status of Card Pair (1; on).
:CTYPe <name>
[:ROUTe]:CONFigure:SLOT[1]:CTYPe <name>
[:ROUTe]:CONFigure:SLOT2:CTYPe <name>
<name>
= C7052
<name> = C7067
= C7053
= C7054
= C7056
= C7057
= C7058
= C7059
= C7061
= C7062
= C7063
= C7064
= C7065
= C7066
:conf:slot:ctyp <name>
:conf:slot2:ctyp <name>
Power-up
Each slot uses the last programmed type, or a 701X card type that is de-
tected.
*RST
No effect
:SYSTem:PRESet
No effect
Assign card ID number for SLOT 1
Assign card ID number for SLOT 2
= C7152
= C7153
= C7154
= C7156
= C7158
= C7164
= C7166
= C7168
= C7169
= C7402
= C9990
= C9991
Advertisement
Table of Contents
