Signal; Tconfigure Commands - Keithley 7001 Instruction Manual

:SIGNal

5.18.8
:ARM[:SEQuence[1]][:LAYer[1]]:SIGNal
:ARM[:SEQuence[1]]:LAYer2:SIGNal
:TRIGger[:SEQuence[1]]:SIGNal
Short-form
:arm:sign
format
These action commands are used to bypass the specified control source and are used when you
Description
do not wish to wait for the programmed event. Keep in mind that the instrument must be waiting
for the appropriate event when the command is sent. Otherwise, an error will occur and this
command will be ignored.
When this command is sent, the specified control source will be bypassed. This will allow op-
eration to continue. Only the layer's source event between is bypassed; any :DELay time will
be observed.
Note that :SIGNal is not an instrument setup command. As soon as this command is executed,
it will attempt to bypass the control source.
Programming
OUTPUT 707; ":trig:sign"
example
TCONfigure commands
5.18.9
:PROTocol <name>
:TRIGger[:SEQuence[1]]:TCONfigure:PROTocol <name>
Parameters
<name> = ASYNchronous
Short-form
:trig:tcon:prot <name>
format
Power-up
Defaults
*RST
:SYSTem:PRESet
Query
:PROTocol?
commands
Short-form format:
Response message:
Artisan Scientific - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisan-scientific.com
Trigger subsystem
! Bypass channel control source.
Asynchronous Trigger Link mode
= SSYNchronous Semi-synchronous Trigger Link mode
Saved power-on setup
ASYNchronous
ASYNchronous
Query programmed Trigger Link protocol
:trig:tcon:prot?
ASYN or SSYN
Bypass arm control source
Bypass scan control source
Bypass channel control source
Specify Trigger Link protocol
IEEE-488 Reference
5-131