Stime <N - Keithley 7001 Instruction Manual

:STIMe <n>
5.13.10
[:ROUTe]:CONFigure:SLOT[1]:STIMe <n>
[:ROUTe]:CONFigure:SLOT2:STIMe <n>
Parameters
<n> = 0 to 99999.999
Short-form
:conf:slot:stim <n>
formats
:conf:slot2:stim <n>
Power-up
Defaults
*RST
:SYSTem:PRESet
Query
:STIMe?
commands
:STIMe? DEFault
:STIMe? MINimum
:STIME? MAXimum
Short-form formats:
Response message:
An internally set relay settling time is provided to allow for switch bounce when it closes. At
Description
power-up, a settling time is automatically set based on the acquired identification information
from the card. The :STIMe command allows you to increase the delay for each slot.
The delay value can be entered using the exponent form. For example, instead of sending a pa-
rameter value of 2000 (seconds), you can instead send 2E3. To cancel this delay, send this com-
mand using a parameter value of 0.
For complete information on this delay, see DELAY in Section 4.
Programming
10
example
20
30
40
Line 10 Sets a 10 second delay for Slot 1 and then queries the delay period.
Line 20 Addresses the 7001 to talk.
Line 30 Displays the delay period (10).
Artisan Scientific - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisan-scientific.com
[:ROUTe] subsystem
Settling time in seconds
= DEFault 0 sec
= MINimum 0 sec
= MAXimum 99999.999 sec
0 sec
0 sec
0 sec
Query programmed delay for specified slot
Query *RST default delay
Query minimum delay
Query maximum delay
:conf:slot:stim?
:conf:slot:stim? def
:conf:slot:stim? min
:conf:slot:stim? max
0 to 99999.999
OUTPUT 707; ":conf:slot:stim 10; stim?"
ENTER 707; A$
PRINT A$
END
Set delay for Slot 1
Set delay for Slot 2
:conf:slot2:stim?
:conf:slot2:stim? def
:conf:slot2:stim? min
:conf:slot2:stim? max
IEEE-488 Reference
5-87