Fastening The Module With Carrier Rail Adapter To A Carrier Rail; Figure 10: Mounting The Carrier Rail Adapter (Exemplary) - WAGO 767-5803 Manual

WAGO-SPEEDWAY 767
767-5803 8DIO 24V DC 0,5A (8xM12)
Pos : 21.18 /Serie 767 ( WAGO-SPEED WAY)/Monti eren/I/O-M odule/Montage_Befestigung auf Tragsc hi enenadapter 767- xxxx allgemein (8xM 12) @ 16\mod_1379057122867_21.doc x @ 131510 @ 3 @ 1
4.4.2 Fastening the Module with Carrier Rail Adapter to a Carrier
Rail
In order to provide a clear representation, the carrier rail adapter in the figure
below is shown without module.
When mounting the module to a carrier rail (DIN rail 35 x 15) using a carrier rail
adapter, proceed as follows:
1. Disconnect the power supply from those devices on which you wish to
mount the module.
2. Set the module onto the edge of the carrier rail (51) with the two notches
(50).
3. Press the undersurface against the lower carrier rail edge until the latch (52)
locks in place.
Rail Adapter for 767 modules with 8xM12 connections
If a 767 module with 8xM12 connections with a rail adapter (item no.: 767-0125)
mounted on a DIN rail, a mounting rail 35 x 15 for use with a height of 15 mm.
Use end stops
When mounting the rail vertically or if shock or vibration loading should occur,
the use of end stops (item no.: 249-116 or 249-117) for stabilization is required.
Pos : 21.19 /Serie 767 ( WAGO-SPEED WAY)/Monti eren/I/O-M odule/Montage_Befestigung auf Tragsc hi enenadapter 767- xxxx - Bil d @ 5\mod_1249030807718_21.doc x @ 39757 @ @ 1

Figure 10: Mounting the carrier rail adapter (exemplary)

Pos : 21.20 /D okumentati on allgemei n/Gli ederungsel emente/---Seitenwec hs el--- @ 3\mod_1221108045078_0.doc x @ 21810 @ @ 1
Manual
Version 1.1.0
50
51
52
Mounting 37