Figure 17: Connectors (Exemplary) - WAGO 767-5803 Manual

50 Connecting Data and Supply Cables
Pos : 23.24 /Serie 767 ( WAGO-SPEED WAY)/Ansc hluss D aten- und Versorgungs kabel/I/O-M odule/Ansc hlus s_Sens oren/Aktoren 767- 5xxx allgemein @ 7\mod_1268056627185_21.doc x @ 51991 @ @ 1
To connect the sensors/actuators to the digital inputs/outputs (X1 – X4) proceed
as follows:
1. Disconnect the power supply from those devices on which you have
mounted the module.
2. Insert the plug of the sensor or actuator cable into the socket of a digital
input/output (3) of the module and tighten it using the knurled-head screw.
3. Screw a protective cap on all unused connections to ensure that the IP 67
degree of protection is adhered to.
Pos : 23.25 /Serie 767 ( WAGO-SPEED WAY)/Ansc hluss D aten- und Versorgungs kabel/I/O-M odule/Ansc hlüs se_8xM12_Sensor en/Aktor en - Bil d @ 11\mod_1317373071707_21.doc x @ 80392 @ @ 1
3
3

Figure 17: Connectors (exemplary)

Pos : 24 /D okumentation allgemei n/Glieder ungs elemente/---Seitenwechs el--- @ 3\mod_1221108045078_0.doc x @ 21810 @ @ 1
3
3
WAGO-SPEEDWAY 767
767-5803 8DIO 24V DC 0,5A (8xM12)
Manual
Version 1.1.0