Marking And Replacing The Marking Spaces; Figure 12: Replacing The Marking Spaces - WAGO 767-5803 Manual

40 Mounting
Pos : 21.26 /Serie 767 ( WAGO-SPEED WAY)/Monti eren/I/O-M odule/Montage_Besc hriftung austauschen 767- xxxx allgemein @ 5\mod_1249034032812_21.doc x @ 39780 @ 2 @ 1
4.6

Marking and Replacing the Marking Spaces

The module marker card (10) and marking strip (12) are attached when delivered.
The protective cover is to be removed when labeling the marking strip. To do this,
proceed as follows:
1. Press the slot screwdriver (maximum slot width: 3mm) into the small
opening under the marking strip cover (12) and lever it up.
2. Remove the marking strip cover.
3. Mark the marking strip with a waterproof pen.
4. Reinsert the marking strip cover and press it firmly in place.
If the module's marker card (10) must be replaced, proceed in accordance with the
step sequence described previously. New module marker cards can be obtained
through WAGO.
Pos : 21.27 /Serie 767 ( WAGO-SPEED WAY)/Monti eren/I/O-M odule/Montage_Besc hriftung austauschen 767- xxxx_8xM12 - Bild @ 11\mod_1317371268949_21.doc x @ 80342 @ @ 1
10

Figure 12: Replacing the marking spaces

Pos : 21.28 /D okumentati on allgemei n/Gli ederungsel emente/---Seitenwec hs el--- @ 3\mod_1221108045078_0.doc x @ 21810 @ @ 1
12
WAGO-SPEEDWAY 767
767-5803 8DIO 24V DC 0,5A (8xM12)
Manual
Version 1.1.0