Pos : 23.22 /Serie 767 ( WAGO-SPEED WAY)/Ansc hluss D aten- und Versorgungs kabel/I/O-M odule/Ansc hlus s_Sens oren/Aktoren 767- 58xx_8xM 12 @ 11\mod_1317718631946_21.doc x @ 80503 @ 2 @ 1
5.5
Connect Sensor/Actuator Cable
The sensor/actuator cable provides power to the connected sensors and actuators.
When using cables that have not been pre-assembled, make sure that these cables
are equipped with M12 plugs rated to IP67. The following table outlines the
assignment of the sensor/actuator connections:
Table 25: Digital inputs/outputs: connection assignment
Connection
IN/OUT
X1, X3, X5,
X7
Table 26: Counter: Assignment of channels for connection assignment
Channel
1
2
3
4
5
6
7
8
Pos : 23.23 /Serie 767 ( WAGO-SPEED WAY)/Wichtige Erläuter ung en/Sic herheits hinweise/Ac htung/Ac htung: Höchs te Strombel astbar bei t der Vers .kontakte( Sens.+ Akt.) und Sensor-/Ac htung: Höc hste Str ombelastbar beit der Vers .kontakte(Sens.+ Akt.) und Sensor-/Aktorstromaufn. 800 mA @ 16\mod_1373020034040_21.doc x @ 125640 @ @ 1
The highest current carrying capacity of the supply contacts is 4 A!
Consider that the sensors and actuators are supplied with power from the U
supply line. Take into account when determining the current energy needs of the
U
supply line, the sensor and actuator power consumption.
A
The total maximum power consumption of the sensors/actors must not
exceed 800 mA!
Please note that the combined power consumption of all connected sensors/actors
is not to exceed 800 mA. The distribution of power among the existing
connections is depending on the individual power requirements of the
Ttl incremental/ssi encoder 2 encoder interfaces (2 x m12) + 4 digital inputs/outputs (2 x m12, 2 inputs/outputs per connector) for wago-speedway 767 (102 pages)