Table 53: Operating Messages 2 - WAGO 767-5803 Manual

86 Diagnostics
Pos : 43.7 /Serie 767 (WAGO-SPEED WAY)/Di agnose/I/O-Modul e/Betriebs mel dungen 767- 58xx F, I/O (Pos. 16 + 17) @ 7\mod_1268129982669_21.doc x @ 52025 @ @ 1

Table 53: Operating messages 2

Pos. LED Color/Status
16 F
17 I/O
Pos : 43.8 /Serie 767 (WAGO-SPEED WAY)/Di agnose/I/O-Modul e/Betriebs mel dungen 767- xxxx U LS und UA (Pos. 18 + 19) @ 8\mod_1278577022948_21.doc x @ 59316 @ @ 1
18 U
A
19 U
LS
Pos : 44 /D okumentation allgemei n/Glieder ungs elemente/---Seitenwechs el--- @ 3\mod_1221108045078_0.doc x @ 21810 @ @ 1
Cause
Red There is at least one global
diagnostic message on the
module.
Yellow Input or output signal
pending.
Red* Error on output.
* If you set the time of the parameter "Restart delay, actuator" (section
"Parameterizing"> "Parameters of outputs") to 0 ms, the I/O LED appears yellow
rather than red in case of a short circuit or overload due to the short restart
interval.
Green Actuator supply U
present.
Off Actuator supply U
present.
Green Logic supply and sensor
supply U
Off Logic supply and sensor
supply U
WAGO-SPEEDWAY 767
767-5803 8DIO 24V DC 0,5A (8xM12)
Remedy/information
Check the supply voltages U
and U
components. For more
information, see the section
"Parameterizing">
"Diagnostic Overview".
-
Check the actuator connection
for short circuit/overload.
A short circuit or overload can
only be diagnosed if the
output is switched on.
is -
A
is not Connect the power supply and
A
check the voltage level, if
applicable.
-
are present.
LS
Connect the power supply and
are not present. check the voltage level, if
LS
applicable.
LS
of the upstream 767
A
Manual
Version 1.1.0