Control Of The Counter Via Inputs And Outputs; Table 48: Connection Assignment For The Counter Function - WAGO 767-5803 Manual

80 Counter Function
9.1

Control of the Counter via Inputs and Outputs

The counter functions (counter) are assigned the sensor and actuator connections
(X1 ... X4) as follows:
• Counter 1
connections X1, X2 (channels 1 ... 4)
• Counter 2
connections X3, X4 (channels 5 ... 8)
The assignment of the counter functions to the individual channels is defined in
the following table. By default, the functions "gate input," "count direction input,"
and "switching output" are deactivated via the inputs and outputs. They then
control the counter via the process data (see section "Control and Monitoring of
the Counter via the Process Data").
In order to control the counter functions via the inputs and outputs of the module,
switch these on via DTMs using WAGOframe or another FDT/DTM framework
application. You can find the necessary DTMs at wago.com. This configuration is
also possible with some fieldbus systems (e.g. PROFIBUSGSD).

Table 48: Connection assignment for the counter function

Inputs and outputs
Counter 1: impulse input
Counter 1: gate input
Counter 1: count direction
input
Counter 1: switching output
Counter 2: impulse input
Counter 2: gate input
Counter 2: count direction
Counter 2: switching output
For detailed information about connection assignment, see section "Connect
Sensor/Actuator Cable".
767-5803 8DIO 24V DC 0,5A (8xM12)
Connector Description
X1 Counter input
Release input:
0: Counter is blocked. Impulses will
X2 not be counted.
1: Counter is released. Impulses will
be counted.
0: Counter counts up.
X3
1: Counter counts downwards.
Counts up:
On reaching the set limit value, the
output is set.
X4
Counts down:
On exceeding the limit value 0, the
output is set.
X5
X6
See counter 1
X7
X8
WAGO-SPEEDWAY 767
Manual
Version 1.1.0