Table of Contents
Advertisement
WAGO-SPEEDWAY 767
767-5803 8DIO 24V DC 0,5A (8xM12)
Pos : 30.16 /Serie 767 ( WAGO-SPEED WAY)/Parametrier en/I/O-Module/Parametrier ung 767- xxxx Gl obal e Parameter @ 7\mod_1265881925390_21.doc x @ 50320 @ 2 @ 1
7.3
Global Settings
Table 36: Overview of parameters for the entire module
Parameter
Simulation diagnostic
Low voltage U
Low voltage U
Pos : 30.17 /Serie 767 ( WAGO-SPEED WAY)/Parametrier en/I/O-Module/Parametrier ung 767-38xx, 5xxx, 6401, 7401 Param. der F el dvers orgung @ 5\mod_1249379780656_21.doc x @ 40285 @ 2 @ 1
7.4
Parameters of Field Supply
Table 37: Overview of adjustable parameters for the field supply
Parameter
Enable field supply
Autorestart delay
Simulation diagnostic
Short circuit/overload
Pos : 30.18 /D okumentati on allgemei n/Gli ederungsel emente/---Seitenwec hs el--- @ 3\mod_1221108045078_0.doc x @ 21810 @ @ 1
Manual
Version 1.1.0
Description
If the checkbox is selected, you can simulate a low voltage diagnostic.
To generate a low voltage diagnostic, one or both of the two checkboxes
"Low voltage U
Default setting: unselected
LS
In the case of an undervoltage of the logic and sensor supply (U
the actuator supply (U
A
Description
Switch on the field supply (24VDC) here.
Default setting: selected
In the event of a short circuit, the sensor supply is switched off for a
certain time. Here, enter this delay time (in 100 ms increments) after
which the sensor supply is restarted.
If the short circuit still exists, the process is repeated.
The simulation can be used to simulate a short circuit.
Default setting: unselected
If simulation is deactivated, the respective error is displayed upon
emergence.
If simulation is activated, you can simulate one of the errors by selecting
the appropriate parameter.
" and "Low voltage U
LS
A
), the corresponding diagnostic is displayed here.
A
Parameterizing
" must be selected.
LS
63
) or
Advertisement
Chapters
Table of Contents
