Dmc20/Dme20 Drive-Cliq Hub; List Of Spare Parts And Accessories - Siemens SIMOTION D410 Manual

Spare parts/Accessories

8.7 List of spare parts and accessories

8.6

DMC20/DME20 DRIVE-CLiQ Hub

Characteristics
The DMC20 and DME20 DRIVE‑CLiQ hub modules are used to implement point-to-point
distribution of a DRIVE‑CLiQ line.
● DMC20 is the hub for the control cabinet configuration
● DME20 is the hub for use without a control cabinet (IP67 degree of protection).
The modules are particularly well suited to applications that require DRIVE-CLiQ link nodes
to be removed in groups without interrupting the DRIVE-CLiQ link and therefore the data
exchange.
The DMC20/DME20 is also used with a D410 when a second encoder is required. As an SMx
Sensor Module and a motor with DRIVE-CLiQ interface only have one DRIVE-CLiQ interface,
a DMC20/DME20 must be used for a second encoder via DRIVE-CLiQ. If a CUA31/CUA32 is
used, the DMC20/DME20 is not required. Alternatively, a second encoder can also be
connected via the X23 interface on the D410.
NOTICE
Overheating if ventilation clearances are too small
Insufficient ventilation clearances result in overheating and therefore in more failures and a
shortened life of the component.
The 50 mm clearances above and below the components must be observed.
Additional references
You will find detailed information about the DMC20/DME20 in the
Units and Additional System Components Manual.
8.7 List of spare parts and accessories
Table 8-5 Spare parts and accessories
Parts for SIMOTION D410
M4 screw-on shield connection
e.g. from Weidmüller GmbH & Co. KG, see:
Internet address (http://www.weidmueller.com)
Protective conductor connection M4/1.8 Nm
e.g. from Weidmüller GmbH & Co. KG, see:
Internet address (http://www.weidmueller.com)
Mounting plate for operation away from the Power Module
Spare fan for SIMOTION D410
100
SINAMICS S120 Control
Order No.
-
-
6AU1400-7AA05-0AA0
6SL3064-0AC00-0AA0
Accessor Spare part
ies
x -
x -
x -
- x
SIMOTION D410
Manual, 04/2014