Clock - Siemens SIMOTION D410 Manual

Input delay, typ. (hardware):
● DI/DO 9-11:
● DI/DO 8
Measuring input input, reproducibility
Table 7-14
Rated load voltage
Permissible range
Electrical isolation
Current load, max.
Residual current, max.
Output delay, typ./max. (hardware)
Output cam output, reproducibility, typ.
Short-circuit protection
Total current of the outputs
Extinguishing energy per output
Lamp load
Maximum lamp load
Switching frequency
● With resistive load, max.
● With inductive load, max.
● With lamp load, max.
1)
2)
7.6

Clock

Features of real-time clock
The table below contains the features and functions of the Control Unit clock.
Table 7-15
Features
Type
Default setting when delivered
SIMOTION D410
Manual, 04/2014
(can also be used as measuring input inputs)
Digital inputs/outputs when used as output
Data for: V = 24 V; load 48 Ω; high ("1") = 90% V
cc
Reproducibility is cycle dependent. Short cycle times must be used for good reproducibility
Clock features
● 0 → 1 signal: 5 µs
● 1 → 0 signal: 50 µs
● 0 → 1 signal: 50 µs
● 1 → 0 signal: 100 µs
5 μs
24 V DC
20.4 ... 28.8 V
no
500 mA per output
2 mA
● 0 → 1 signal: 150 µs / 400 µs
1)
● 1 → 0 signal: 75 µs / 100 µs
● 200 μs with 3 ms bus/servo cycle clock
2)
● 300 μs with 6 ms bus/servo cycle clock
yes
Maximum permitted total current at X121 each
1 A over the total operating temperature range
(equals 50 % coincidence)
400 mJ
1 A for 50 ms
5 W
● 100 Hz
● 0.5 Hz
● 10 Hz
; low ("0") = 10% V
out
Description
Hardware clock (integrated "real-time clock")
DT#1992-01-01-00:00:00
Technical data
7.6 Clock
out
91