Siemens SIMOTION D410 Manual page 17

1. Unintentional movements of driven machine components during commissioning, operation,
2. In the event of a fault, exceptionally high temperatures, including an open fire, as well as
3. Hazardous touch voltages caused by, for example:
4. Electrical, magnetic and electromagnetic fields generated in operation that can pose a risk
5. Release of environmental pollutants or emissions as a result of improper operation of the
Note
The components must be protected against conductive contamination (e.g. by installing them
in a control cabinet with degree of protection IP54 according to IEC 60529 or NEMA 12).
Assuming that conductive contamination at the installation site can definitely be excluded, a
lower degree of cabinet protection may be permitted.
SIMOTION D410
Manual, 04/2014
maintenance, and repairs caused by, for example:
– Hardware defects and/or software errors in the sensors, controllers, actuators, and
connection technology
– Response times of the controller and drive
– Operating and/or ambient conditions outside of the specification
– Condensation / conductive contamination
– Parameterization, programming, cabling, and installation errors
– Use of radio devices / cellular phones in the immediate vicinity of the controller
– External influences / damage
emissions of light, noise, particles, gases, etc. can occur inside and outside the inverter,
for example:
– Component malfunctions
– Software errors
– Operating and/or ambient conditions outside of the specification
– External influences / damage
Inverters of the Open Type / IP20 degree of protection must be installed in a metal control
cabinet (or protected by another equivalent measure) such that the contact with fire inside
and outside the inverter is not possible.
– Component malfunctions
– Influence of electrostatic charging
– Induction of voltages in moving motors
– Operating and/or ambient conditions outside of the specification
– Condensation / conductive contamination
– External influences / damage
to people with a pacemaker, implants or metal replacement joints, etc. if they are too close.
system and/or failure to dispose of components safely and correctly.
Safety instructions
1.1 Fundamental safety instructions
17