Siemens SIMOTION D410 Manual page 27

Interfaces
The SIMOTION D410 DP interfaces are described in the following tables.
Table 2-5
Interface
Digital inputs/outputs
X121
DRIVE-CLiQ interface
X100
PROFIBUS DP interface
X21
Power Module Interface
(PM-IF)
Encoder interface (HTL/TTL/
SSI)
X23
EP terminals/temperature
sensor connection
X120
Power supply connection
X124
Measuring sockets
T0, T1, T2 and M
Type plates
The following figure shows you all the information included on the type plate located on the
side of the unit.
Figure 2-3
SIMOTION D410
Manual, 04/2014
SIMOTION D410 interfaces
Description
12-pin Mini Combicon:
● 4 digital inputs: for connecting switches or proximity sensors
● 4 digital inputs/outputs: for connecting actuators and sensors
8-pin RJ45plus socket to connect DRIVE-CLiQ nodes
9-pin SUB-D socket to connect to PROFIBUS DP
8-pin direct connector to connect to a blocksize power module
15-pin SUB-D socket for connecting HTL, TTL and SSI encoders.
8-pin Mini Combicon for connecting Safety Integrated input terminals
or for connecting temperature sensing via KTY or PTC
4-pin screw terminal connection to connect the 24 V DC load power
supply
Sockets to output analog signals
SIMOTION D410 nameplate
Description
2.3 SIMOTION D410 DP display
27