Seeley Climate Wizard CW-80 Installation & Operation Manual page 53

APPENDIX B COMMISSIONING cont.
Owner Name: ...................................................................
Address: ..............................................................................
............................................................................................
Dealer: ...............................................................................
Date Installed: ..................................................................
INSTALLATION CHECKS
The cooler is adequately supported, secure and level.
The water pipes were flushed of any foreign materials before connection the cooler was made.
The owner has been instructed on how to isolate the water to the system in case of emergency.
The water is connected with no leaks at fittings.
Water pipes are correctly saddled as per the applicable plumbing regulations.
The power supply adheres to all local and national regulations and is wired back to the distribution board on its own separate circuit
All cables have been correctly connected to the control boxes (i.e. power supply, control cable)
The owner has been instructed how they can electrically isolate the cooler at the meter box in case of an emergency.
All ducts are fixed correctly and there are no air leaks.
The system has been run from the customer's BMS control and all functions work correctly.
The customer has been shown how to operate the system.
All the installation rubbish has been removed and, if applicable, any property damage repaired.
Visual inspection completed no damage
Electrical supply to cooler OK
Inlet filter media OK
Cooler internal water levels checked
COMMISSIONING CHECKS
Confirm the chlorine content in the water system is between 0.5 - 1 ppm
Internal component check OK
Outlet CW drain directed into open drain YES/NO.
Confirm that all screws are tight. Screws may have loosened during shipment.
Check supply duct is sealed. Water can be directed at joins to confirm this.
Check all wiring connections
Check Supply tank level sensor function on screen
Check for air leaks
Cooler function test with control function check OK
Confirm BMS interface
Water inlet flow meets specification
ON-SITE SELECTED SET POINTS
ITEM
Supply Fans de-rating factor
Control system error actions
Touch screen display units
Signed by Installer: .........................................................
Dated: ...............................................................................
Telephone: .......................................................................
Installer: ...........................................................................
Model No: .........................................................................
Serial No: ..........................................................................
Setting Range
40 to 100%
Standard or Critical
Metric or Imperial
Commissioning Engineer: ..............................................
Dated: ...............................................................................
INSTALLATION, OPERATION & MAINTENANCE MANUAL 866600CE-B | 53
Actual Setting Used