Siemens ARCADIS Varic Operator's Manual page 397

Parameter settings
Changing parameters
ARCADIS Varic
SPR2-310.620.30.02.02
You can change the following parameters on the tab card:
Parameters
Opacification
Dose Level
Landmark
Bone Display
Autostore
Duration Phase B1
Storage Rate Phase B1 f/s
Storage Rate (Phase B2) f/s
Autoloop
Select the required new parameters from the selection lists.
Click this button.
– Your changes are applied to the ARCADIS Varic system.
– The configuration dialog remains open for further entries.
Continue configuring the next operating mode on the corresponding tab card.
— or —
Click this button.
– The dialog box closes.
Configuration
Remarks
Possible values: min, max
Possible values: medium, high
With the slider: 0 to 30%, in steps of
5%
Possible values: white, black
off (no automatic storage)
Phase B1, phase B2 (saves only
images of the respective phase)
all (all images are stored)
Disabled if Autostore = 'off', other-
wise enabled
Enabled if Autostore = 'all' and a dura-
tion phase B1 > 0 is set
Enabled if Autostore = 'all'
Check box for activating automatic
playback of a sequence of images at
the end of the exposure
19
of 24