2.11.3 Parameters related to EtherNet/IP
The following parameters are used for EtherNet/IP communication. Set the parameters as required.
Pr.
1426
Link speed and duplex mode
*1
selection
N641
1442
Ethernet IP filter address 1
*1
N660
1443
Ethernet IP filter address 2
*1
N661
1444
Ethernet IP filter address 3
*1
N662
1445
Ethernet IP filter address 4
*1
N663
1446
Ethernet IP filter address 2
*1
range specification
N664
1447
Ethernet IP filter address 3
*1
range specification
N665
1448
Ethernet IP filter address 4
*1
range specification
N666
*1
The setting is applied after an inverter reset or next power-ON.
Communication speed and full-duplex/half-duplex selection (Pr.1426)
Use Pr.1426 Link speed and duplex mode selection to set the communication speed and the full-duplex or half-duplex
system. If the operation is not performed properly in the initial setting (Pr.1426 = "0"), set Pr.1426 according to the
specifications of the connected device.
Communication
Pr.1426 setting
Automatic
0 (initial value)
negotiation
1
100 Mbps
2
100 Mbps
3
10 Mbps
4
10 Mbps
102
2. Ethernet Communication
2.11 EtherNet/IP
Initial
Name
value
0
0
0
0
0
9999
9999
9999
Full-duplex/half-
speed
duplex system
Automatic
negotiation
Full duplex
Half duplex
Full duplex
Half duplex
Setting range
Set the communication speed and the communication mode
0 to 4
(full-duplex/half-duplex).
0 to 255
Set the range of connectable IP addresses for the network
devices.
(When Pr.1442 to Pr.1445 = "0 (initial value)", the function
is invalid.)
0 to 255, 9999
The communication speed and the communication mode (half-duplex/full-
duplex) are automatically negotiated to ensure the optimum setting. To set
automatic negotiation, auto negotiation setting is required also in the master
station.
—
—
—
—
Description
Remarks