Initial Setting For Cc-Link Ie Field Network Basic - Mitsubishi Electric 800 Series Instruction Manual

NOTE
• If the FR-E800-E cannot be detected, on the menu bar select [Diagnostics (D)] > [CC Link IEF Basic Diagnostics]. The "CC
Link IEF Basic Diagnostics" window will be displayed. The network status or fault records can be checked.
2.6.3

Initial setting for CC-Link IE Field Network Basic

Use the following parameters to perform required settings for Ethernet communication between the inverter and other devices.
To make communication between other devices and the inverter, perform the initial settings of the inverter parameters to match
the communication specifications of the devices. Data communication cannot be made if the initial settings are not made or if
there is any setting error.
Pr. Name
1427
Ethernet function
*1
selection 1
N630
1428
Ethernet function
*1
selection 2
N631
1429
Ethernet function
*1
selection 3
N632
1430
Ethernet function
*1
selection 4
N633
1432 Ethernet communication
N644 check time interval
36
2. Ethernet Communication
2.6 CC-Link IE Field Network Basic
Initial
Setting range
value
5001
502, 5000 to 5002, 5006
45237 to 5008, 5010 to 5013,
*3
9999, 34962 , 44818
45238 45237, 45238, 47808
61450
9999
0
1.5 s
0.1 to 999.8 s
9999
*2
, Set the application, protocol, etc.
*2
,
Ethernet communication is available, but the inverter output is
shut off in the NET operation mode.
Set the interval of the communication check (signal loss
detection) time for all devices with IP addresses in the range
specified for Ethernet command source selection (Pr.1449 to
Pr.1454).
If a no-communication state persists for longer than the
permissible time, the inverter output will be shut off.
No communication check (signal loss detection)
Description