Wi-Fi Wan - peplink Pepwave MAX Series User Manual

10.3 Wi-Fi WAN

To access Wi-Fi WAN settings, click Network>WAN>Details.
WAN Connection
Enter a name to represent this WAN connection.
Name
Operating
Click the drop-down menu to apply a time schedule to this interface.
Schedule
If this is checked, the connection will be working independent from other Backup WAN
Independent from
connections. Those in Backup Priority will ignore the status of this WAN connection, and will be
Backup WANs
used when none of the other higher priority connections are available.
This setting specifies the state of the WAN connection while in standby. The available options are
Standby State
Remain Connected (hot standby) and Disconnect (cold standby).
This setting specifies the maximum transmission unit. By default, MTU is set to Custom 1440.
You may adjust the MTU value by editing the text field. Click Default to restore the default MTU
MTU
value. Select Auto and the appropriate MTU value will be automatically detected. The auto-
detection will run each time the WAN connection establishes
Reply to ICMP
If this setting is disabled, the WAN connection will not respond to ICMP ping requests. By
default, this setting is enabled.
PING
http://www.peplink.com
WAN Connection Settings
73 Copyright @ 2017 Pepwave