Qos; User Groups - peplink Pepwave MAX Series User Manual

18 QoS

18.1 User Groups

LAN and PPTP clients can be categorized into three user groups: Manager, Staff, and Guest. This
menu allows you to define rules and assign client IP addresses or subnets to a user group. You can apply
different bandwidth and traffic prioritization policies on each user group in the Bandwidth
Control and Application sections (note that the options available here vary by model).
The table is automatically sorted by rule precedence. The smaller and more specific subnets are put
towards the top of the table and have higher precedence; larger and less specific subnets are placed
towards the bottom.
Click the Add button to define clients and their user group. Click the
rule. Two default rules are pre-defined and put at the bottom. They are All DHCP reservation
clients and Everyone, and they cannot be removed. The All DHCP reservation client represents the
LAN clients defined in the DHCP Reservation table on the LAN settings page. Everyone represents all
clients that are not defined in any rule above. Click on a rule to change its group.
From the drop-down menu, choose whether you are going to define the client(s) by an IP
Address or a Subnet. If IP Address is selected, enter a name defined in DHCP reservation table
Subnet / IP Address
or a LAN client's IP address. If Subnet is selected, enter a subnet address and specify its subnet
mask.
Group
This field is to define which User Group the specified subnet / IP address belongs to.
Once users have been assigned to a user group, their internet traffic will be restricted by rules defined
for that particular group. Please refer to the following two sections for details.
http://www.peplink.com
Add / Edit User Group
119
button to remove the defined
Copyright @ 2017 Pepwave