Pppoe Connection - peplink Pepwave MAX Series User Manual

10.1.3 PPPoE Connection

This connection method is suitable if your ISP provides a login ID/password to connect via PPPoE.
Routing Mode
IP Address / Subnet
Mask / Default Gateway
PPPoE User Name /
Password
Confirm PPPoE
Password
Service Name (Optional)
IP Address (Optional)
DNS Servers
http://www.peplink.com
PPPoE Settings
NAT allows substituting the real address in a packet with a mapped address that is
routable on the destination network. By clicking the help icon in this field, you can
display the IP Forwarding option, if your network requires it.
This information is obtained from the ISP automatically.
Enter the required information in these fields in order to connect via PPPoE to the ISP. The
parameter values are determined by and can be obtained from the ISP.
Verify your password by entering it again in this field.
Service name is provided by the ISP.
Note: Leave this field blank unless it is provided by your ISP.
If your ISP provides a PPPoE IP address, enter it here.
Note: Leave this field blank unless it is provided by your ISP.
Each ISP may provide a set of DNS servers for DNS lookups. This setting specifies the DNS
(Domain Name System) servers to be used when a DNS lookup is routed through this
connection. Selecting Obtain DNS server address automatically results in the DNS servers
being assigned by the WAN DHCP server to be used for outbound DNS lookups over the
connection. (The DNS servers are obtained along with the WAN IP address assigned from
the DHCP server.) When Use the following DNS server address(es) is selected, you may
enter custom DNS server addresses for this WAN connection into the DNS Server 1 and
DNS Server 2 fields.
65 Copyright @ 2017 Pepwave