Netflow; Wi-Fi Air Monitoring; Sp Default Configuration; Peplink Relay - peplink PEPWAVE Balance One User Manual

4.10

NetFlow

NetFlow protocol is used to track network traffic. Tracking information from NetFlow can be sent
to the NetFlow collector, which analyzes data and generates reports for review.
Note : To enable this feature, go to https://<Device's IP>/cgi-bin/MANGA/support.cgi
4.11

Wi-Fi Air Monitoring

Peplink routers support Wi-Fi "Air Monitoring Mode" which is used to troubleshoot remotely and
proactively monitor Wi-Fi and WAN performance. After enabling Wi-Fi Air Monitoring, reports
can be viewed under InControl 2 > Reports > AirProbe Reports .
Note : To enable this feature, go to https://<Device's IP>/cgi-bin/MANGA/support.cgi
4.12 SP Default Configuration
The SP Default Configuration feature written in the updated KB article allows for the
provisioning of custom made settings (a.k.a. InControl2 configuration) via the Ethernet LAN port
and is ideal for those wanting to do a bulk deployment of many Peplink devices.
Note : If you would like to use this feature, please contact your purchase point (Eg.VAD).
4.13

Peplink Relay

Cloud Service Providers often restrict access to certain applications. With SFC Relay, you can
route traffic before going out to the Internet, allowing access to previously restricted applications
experienced with the public SpeedFusion Cloud nodes. Available as an add-on for your home
router or as an upgradable license to your Peplink router, SFC Relay is sure to impress you and
any peers you give access to.
https://forum.peplink.com/t/configure-speedfusion-cloud-relay-server-and-client/6215ca9b017e4
8e0f3ff2479/
https://www.peplink.com 18 Copyright @ 2022 Peplink