Pppoe Connection; Server Name - peplink ONE 20 User Manual

USER MANUAL
Peplink Balance Series

14.2.3 PPPoE Connection

This connection method is suitable if your ISP provides a login ID/password to connect
via PPPoE.
PPPoE User
Enter the required information in these fields in order to connect via PPPoE to your ISP.
Name /
The parameter values are determined by and can be obtained from your ISP.
Password
Confirm PPPoE
Verify your password by entering it again in this field.
Password

Server Name

Server name is a PPPoE parameter which is provided by your ISP.
Note: Leave this field blank unless it is provided by your ISP.
(Optional)
PPPoE server address is a parameter which is provided by your ISP.
IP Address
Note: Leave this field blank unless it is provided by your ISP.
Each ISP may provide a set of DNS servers for DNS lookups. This setting specifies the
DNS (Domain Name System) servers to be used when a DNS lookup is routed through this
connection.
Selecting Obtain DNS server address automatically results in the DNS servers assigned
DNS Servers
by the PPPoE server to be used for outbound DNS lookups over the WAN connection.
(The DNS servers are obtained along with the WAN IP address assigned from the PPPoE
server.)
When Use the following DNS server address(es) is selected, you can enter custom DNS
server addresses for this WAN connection into the DNS server 1 and DNS server 2 fields.
Please refer to Sections 14.3, 14.4, 14.5, and 14.6 for details about WAN Health
Check, Bandwidth Allowance Monitor, Additional Public IP Settings, and Dynamic
DNS Settings.
A PPPoE connection made from a firewall does not work with drop-in mode.
http://www.peplink.com
PPPoE Settings
Note
-101 / 269 - Copyright © 2016 Peplink