Pppoe Connection - peplink Balance One User Manual

USER MANUAL
Peplink Balance Series

11.1.3 PPPoE Connection

This connection method is suitable if your ISP provides a login ID/password to connect via PPPoE.
PPPoE User Name
Enter the required information in these fields in order to connect via PPPoE to your ISP.
/ Password
The parameter values are determined by and can be obtained from your ISP.
Confirm PPPoE
Verify your password by entering it again in this field.
Password
Service Name
Service Name is a PPPoE parameter which is provided by your ISP.
Note: Leave this field blank unless it is provided by your ISP.
(Optional)
Each ISP may provide a set of DNS servers for DNS lookups. This setting specifies the
DNS (Domain Name System) servers to be used when a DNS lookup is routed through this
connection.
Selecting Obtain DNS server address automatically results in the DNS servers assigned
DNS Servers
by the PPPoE server to be used for outbound DNS lookups over the WAN connection.
(The DNS servers are obtained along with the WAN IP address assigned from the PPPoE
server.)
When Use the following DNS server address(es) is selected, you can put custom DNS
server addresses for this WAN connection into the DNS server 1 and DNS server 2 fields.
Please refer to section 11.3, 11.4, 11.5, and 11.6 for details about WAN Health Check, Bandwidth
Allowance Monitor, Additional Public IP Settings, and Dynamic DNS Settings.
A PPPoE connection made from a firewall does not work with Drop-in Mode.
http://www.peplink.com
PPPoE Settings
Note
-77 / 227 - Copyright © 2014 Peplink