Table of Contents
Advertisement
Figure 14. LCD panel features
Table 12. LCD panel features
Item
Button or display
1
Left
2
Select
3
Right
4
LCD display
Viewing Home screen
The Home screen displays user-configurable information about the system. This screen is displayed during normal system operation when
there are no status messages or errors. When the system turns off and there are no errors, LCD enters the standby mode after five
minutes of inactivity. Press any button on the LCD to turn it on.
1
To view the Home screen, press one of the three navigation buttons (Select, Left, or Right).
2
To navigate to the Home screen from another menu, complete the following steps:
a
Press and hold the navigation button till the up arrow
b Navigate to the Home icon
c
Select the Home icon.
d On the Home screen, press the Select button to enter the main menu.
Setup menu
NOTE:
When you select an option in the Setup menu, you must confirm the option before proceeding to the next action.
Option
Description
iDRAC
Select DHCP or Static IP to configure the network mode. If Static IP is selected, the available fields are IP,
Subnet (Sub), and Gateway (Gtw). Select Setup DNS to enable DNS and to view domain addresses. Two
separate DNS entries are available.
Set error
Select SEL to view LCD error messages in a format that matches the IPMI description in the SEL. This enables you
to match an LCD message with an SEL entry.
Description
Moves the cursor back in one-step increments.
Selects the menu item highlighted by the cursor.
Moves the cursor forward in one-step increments.
During message scrolling:
•
Press and hold the right button to increase scrolling speed.
•
Release the button to stop.
NOTE:
The display stops scrolling when the button is released. After 45
seconds of inactivity, the display starts scrolling.
Displays system information, status, and error messages or iDRAC IP address.
is displayed.
using the up arrow
.
Dell EMC PowerEdge R440 overview
19
Advertisement
Table of Contents
