Megabyte Hard Disk Drive Configuration Jumper Locations - HP 9000 300 Series Hardware Configuration Manual

6
52 Mbyte Hard Disk Drives
Setting Configuration Jumpers
Caution
Although the device is well-protected from physical shock
when installed in the controller, it is very easily damaged when
separate. Avoid dropping or striking the device. Handle it
gently at all times.
Figure 6-2 shows you the configuration jumper locations. Jumpers and their
settings are explained in Table 6-1.
Note the jumpers in the back of the drive are installed as follows:
• Jumpers installed on pins
=
"in."
• Jumpers removed from pins
=
"out."
Figure 6-1. 52 Megabyte Hard Disk Drive Configuration Jumper Locations
6-6 Configuring Mass Storage Devices