Setting The Interrupt Level - HP 9000 300 Series Hardware Configuration Manual

10
Setting the Interrupt Level.
SKIP? The interface is preset to interrupt level 3. Unless you
are certain that interrupt level 3 is inappropriate for your
.application, leave the interrupt level setting alone and skip to
to the next configuration function.
1. Find the group of eight switches on the interface by referring to Figure 10-7.
Switches 2 and 3 in this group determine the interrupt level.
2. Set the interrupt level to the desired value by referring to Table 10-14:
Table 10-14.
Interrupt Switch Switch
Level 2 3
3 0 0
4
0
1
5 1 0
6
1 1
Setting the Remote Switch.
SKIP?
If you are
not
connecting your system console to port 1 of
this interface, skip to step 5. The Remote switch is preset to
"local," which does
not
configure port 1 to be the system
console.
1. Find the group of eight switches on the interface by referring to Figure 10-7.
Switch 1 in this group is the Remote switch.
10-26 Configuring Popular Accessory Cards