HP 9000 300 Series Hardware Configuration Manual page 33

3
This Configurable Interfaces
menu replaces the
Configuration Control menu:
Configurable Interfaces
Keys Interface Select Code
1 LAJl
2 HP-IB
3
SCSI
4 HP Parallel
5
RS-232
. N store New values
21
14
12
9
D store Default values
(then cycle SPU power)
A Abort without changes
Type [key] RETURN
?
The order that interface identifiers appear and their respective number keys
may be different on your controller. Only interfaces that are configurable from
the Boot ROM's Configuration Control Mode will be listed. The Select Code
currently assigned to the interfaces is shown in the column marked "Select
Code" .
Each of the number and letter key commands is explained below . Note that
the
(Return
1/(
Enter
1
key must be pressed after pressing the command key.
Configuring Internal Interfaces and Boot Modes 3·3
3