2
Using the Power-Up Display
Follow these steps to determine your controller's hardware configuration:
1. If your controller is operating, shut down the operating system following
normal procedures. Refer to your controller's Owner's Guide for
instructions.
2. Turn off your controller, then turn it ON.
3. When the power-up display shown in Figure 2-1 lists the line:
HP-HIL.Keyboard
and before the operating system boots, press the
(Space bad.
Copyright 1991
Hewlett-Packard Company
All Rights Reserved
BOOTROM Rev. 3.01 2 MAY 91
Bit-Mapped Video
MC68030 Processor
Configuration EEPROM
Utility Chip at 41
HP-HIL.Keyboard
DMA-CO
RAM xxxxxxx Bytes
Digital Audio at 8
HP Parallel at 12
HP98265 (SCSI S 32) at 14
HP98643 (LAN) at 21, THIN,
0800091595F3
System Search Mode
RESET To Restart
Figure 2-1. Power-Up Display
2-2
Finding Your Controller's Existing Configuration