configuration jumpers. Set your drive's SCSI configuration jumpers for the
SCSI bus address it will use.
Note that jumper
ID
0 is next to the edge of the printed circuit board. For
example,
if
you want to set your hard disk drive's address jumpers to address
5, you would set:
• Jumper
ID
0 out.
• Jumper
ID
1 in.
• Jumper
ID
2 out.
SCSI Bus Address Jumpers
The hard disk drive must be set to a unique SCSI bus address. Use a pair
of needle-nose pliers to set the drive's SCSI address. The address is binary
(jumper in = 1, out = 0) with jumper AO the lease significant bit.
Configuring the Operating System
Refer to your Owner's Guide or other operating system documentation to
configure your operating system for the drive.
Configuring Mass Storage Devices
6-13
6