HP 9000 300 Series Hardware Configuration Manual page 141

10
Table 10-17.
Interrupt Switch Switch
Level
6
7
3
0 0
4
0 1
5 1 0
6
1 1
Setting the Interface Type.
Refer to Figure 10-9 to find the interface type
jumper.
That jumper selects either LAN Ethernet or IEEE 802.3 interface type. Most
applications require the IEEE 802.3 LAN interface type. If your application
requires the Ethernet type, change the jumper to the two pins next to the
ENET
label next to the jumpers.
Reinstalling the LAN Interface Card
Insert the LAN interface card, component side up, into its slot. Tighten the
thumb screws on the metal end plate until the end plate is flush with the back
of the controller.
Verification Test
1. Plug in your controller's power cord and video cable, then turn on your
monitor and controller.
2. When the keyboard line appears, press
(space
bar)
a few times to go into
attended mode.
3. Check the interfaces listed on the left-hand side of the screen:
• If the message,
HP98643,
is listed, you have correctly installed the LAN
Interface.
10-32 Configuring Popular Accessory Cards