Floating-Point Accelerator Chip Presence; Determining Internal Interface Configurations - HP 9000 300 Series Hardware Configuration Manual

Hide thumbs

Advertisement

Table of Contents
Floating-Point Accelerator Chip Presence
Note
This section applies to Model 362 controllers only.
Look for a line on the left side that reads:
MC68882 Coprocessor
If that line appears, your Model 362 controller has the floating-point
accelerator coprocessor chip installed.
Determining Internal Interface Configurations
The Boot ROM configuration mode is used for internal interface configurations
or Auto System Selection for your controller.
Configure Mode is run and controlled by the Boot ROM. You do not need to
have an operating system installed to use Configure Mode.
If the operating system is installed and you want to enter Configure Mode, you
must prevent the operating system from booting. Instructions are provided in
this chapter.
Finding Your. Controller's Existing Configuration
2-5
2

Advertisement

Table of Contents
loading

  Related Manuals for HP 9000 300 Series

This manual is also suitable for:

362382

Table of Contents