Preliminary Requirements - HP 9000 300 Series Hardware Configuration Manual

7
Preliminary Requirements
Before you start to reconfigure your CD ROM drive, refer to Chapter 3 and 4
to
1. Shut down your controller's application program and operating system.
2. Turn OFF your controller and unplug all cords and cables from it and any
attached expanders.
3. Access the controller's internal assemblies.
Model 362 Controllers
There is one jumper on the low-resolution system board for on-board graphics
configuration. The jumper is marked
ENABLE.
The default condition is nearest
the marking. Moving the
ENABLE
jumper causes the on-board graphics circuitry
to be disabled, allowing a supported graphics board to be used in the DID slot.
Refer to Figure 7-1 for jumper positions.
Figure 7-1. Model 362 System Board Graphics Jumper
7 -2 Configuring Graphics Mode