Software Installation Of The Hard Disk Drive Upgrade - HP 9000 300 Series Owner's Manual

Configuring for a Hard Disk Drive
Hard disk drive upgrades can be installed to accommodate local le systems
and swap space on your workstation.

Software Installation of the Hard Disk Drive Upgrade

After hardware installation has been completed (see the
for this device), you'll need to ensure that your operating system is prepared
to exchange data with the device. This section provides instructions for
con guring HP-UX to communicate with a hard disk drive upgrade. Note that
your HP disk is pre-formatted.
Caution
The factory-set SCSI bus address for the disk drive:
For an upgrade disk drive: SCSI bus address:
6
This SCSI address assumes usage of the disk as
con guration jumpers in the back of the drive are factory-installed and should
not require recon guring, it is possible that the SCSI bus address jumpers for
an upgrade may be shipped with di erent settings. Therefore, please see the
Installation Guide for the drive for the procedure for resetting jumpers, should
it be necessary.
The following list outlines the software procedures you'll nd in this section for
installing the hard disk drive as a le system disk:
Use SAM to do the following:
Con gure an unused device le with the select code and bus address for
your device.
Build a le system on the disk.
Mount the disk so that you can access it as a le system.
6-8 Configuring HP-UX for Printers and Drives
Get user manuals: See SafeManuals.com
Although the device is well-protected from physical shock when
installed in the workstation, it is very easily damaged when
separate. Avoid dropping or striking a device.
Installation Guide
6
. Although the
root