HP 9000 300 Series Hardware Configuration Manual page 140

Setting the Select Code.
1. Remove the LAN card from the controller or expander and place it on a
static-free surface.
2. Find the group of switches labeled SW1 by referring to Figure 10-9.
Switches 3 through 8 in this group determine the select code.
3. Set these switches to one of the five select codes given in Table 10-16, unless
you have used them elsewhere Refer to the installation note that came with
the interface if you need additional switch settings.
Table 10-16. LAN Card Select Code Switch Settings
Switch Switch Switch Switch Switch Select
5
4 3
2 1
Code
1 0 1 0 1 21
0 1 1 0 1 22
1 1 1 0 1 23
0 0 0
1 1 24
1 0 0 1 1 25
4. Make a note that the select code has been used and is no longer available.
5. Find the new select code's number in the set of select code labels supplied
with the interface. Replace the card's select code label with this new label.
If a number is not available, make a label that looks like the one removed
and stick it on the LAN card.
Setting the Interrupt Level.
1. Find the group of switches labeled SW1 by referring to Figure 10-9.
Switches 6 and 7 in this group determine the interrupt level.
2. Set the interrupt level to the desired value by referring to Table 10-17.
Configuring Popular Accessory Cards 10-31
10