Table of Contents
Advertisement
Refer to "ASSEMBLING THE FRONT
WHEEL" on page 4-25.
EAS30167
MAINTENANCE OF THE REAR WHEEL
SENSOR AND SENSOR ROTOR
ECA21060
NOTICE
• Handle the ABS components with care
since they have been accurately adjusted.
Keep them away from dirt and do not sub-
ject them to shocks.
• The rear wheel sensor cannot be disassem-
bled. Do not attempt to disassemble it. If
faulty, replace with a new one.
• Keep any type of magnets (including mag-
netic pick-up tools, magnetic screwdrivers,
etc.) away from the rear wheel sensor or
rear wheel sensor rotor.
• Do not drop or shock the wheel sensor or
the wheel sensor rotor.
1. Check:
• Rear wheel sensor
Refer to "MAINTENANCE OF THE FRONT
WHEEL SENSOR AND SENSOR ROTOR"
on page 4-26.
2. Check:
• Rear wheel sensor rotor
Refer to "MAINTENANCE OF THE FRONT
WHEEL SENSOR AND SENSOR ROTOR"
on page 4-26.
3. Measure:
• Wheel sensor rotor runout
Refer to "MAINTENANCE OF THE FRONT
WHEEL SENSOR AND SENSOR ROTOR"
on page 4-26.
EAS30164
ADJUSTING THE REAR WHEEL STATIC
BALANCE
TIP
• After replacing the tire, wheel or both, the rear
wheel static balance should be adjusted.
• Adjust the rear wheel static balance with the
brake disc and rear wheel pulley installed.
Adjust:
• Rear wheel static balance
Refer to "ADJUSTING THE FRONT WHEEL
STATIC BALANCE" on page 4-27.
EAS30165
INSTALLING THE REAR WHEEL (DISC
BRAKE)
1. Install:
• Rear wheel sensor rotor
• Rear brake disc
Rear wheel sensor bolt
7 N·m (0.7 kgf·m, 5.2 lb·ft)
Rear brake disc bolt
30 N·m (3.0 kgf·m, 22 lb·ft)
LOCTITE®
ECA19150
NOTICE
Replace the brake disc bolts with new ones.
TIP
• Install the wheel sensor rotor with the stamped
mark "1" facing outward.
• Tighten the brake disc bolts in stages and in a
crisscross pattern.
1
2. Check:
• Rear brake disc
Refer to "CHECKING THE REAR BRAKE
DISC" on page 4-61.
3. Install:
• Drive belt guide
• Rear wheel pulley
4-36
REAR WHEEL
C
Advertisement
Table of Contents
Troubleshooting
