6. If the smart key is registered successfully, the smart key system indicator light " " will come on for
3 seconds, and then the smart key system will turn off.
If the smart key was not registered successfully, the smart key system indicator light " " will flash
for 3 seconds, and then the smart key system will turn off.
TIP
If this registration procedure is performed for a smart key that is already registered, the smart key sys-
tem indicator light " " will flash for 7 seconds (on for 0.2 second and off for 0.8 second).
EAS31537
DISABLING A SMART KEY
If a smart key is lost or stolen, the smart key can be disabled.
1. Place all of the smart keys "1" 300 cm (118.1 in) "a" or more away from the vehicle or lock the com-
munication.
2. Perform steps (1) to (7) in "SMART KEY SYSTEM EMERGENCY MODE" on page 8-207.
3. While the smart key system indicator light " " is on for 10 seconds, perform the following procedure.
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. While pushing the OFF/LOCK switch "1", push the Parking/Unlock switch "2" 3 times. Then, release
both switches.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
4. Check that the smart key system indicator light " " goes off (the smart key disable mode is activat-
ed).
5. Turn on (unlocked setting) the smart keys that you want to enable and place them within 80 cm (31.5
in) of the remote control unit.
6. Push the OFF/LOCK switch 1 time to start the communication between the remote control unit and
the smart keys that are located within 80 cm (31.5 in) of the unit.
TIP
The number of smart keys that currently can be used will be indicated.
Number of flashes = Number of verified smart keys. (1 cycle of on for 0.3 second and off for 0.3 second
= 1 smart key)
1
2
SMART KEY SYSTEM
a
8-210
1