Fault Code No. P2195 - Yamaha TMAX XP530E-A 2017 Service Manual

Fault code No. P2195

TIP
If fault code numbers "P0657", "P2195" and "P0030", two or more numbers are indicated, take the ac-
tions specified for fault code number "P0657", "P0030" and "P2195" in the order.
Fault code No.
Item
Fail-safe system
Diagnostic code No.
Tool display
Procedure
Probable cause of malfunc-
Item
tion and check
1 Installed condition of O
2 Connection of O
pler.
Check the locking condition of
the coupler.
Disconnect the coupler and
check the pins (bent or broken
terminals and locking condition
of the pins).
3 Connection of ECU coupler.
Check the locking condition of
the coupler.
Disconnect the coupler and
check the pins (bent or broken
terminals and locking condition
of the pins).
P2195
O sensor: open circuit detected.
2
Able to start engine
Able to drive vehicle
—
—
—
sensor. Check for looseness or pinch-
2
ing.
Improperly installed sensor 
Reinstall or replace the sensor.
Improperly connected  Con-
sensor cou-
2
nect the coupler securely or
replace the wire harness.
Improperly connected  Con-
nect the coupler securely or
replace the wire harness.
FUEL INJECTION SYSTEM
Maintenance job
8-113
Confirmation of service com-
pletion
Start the engine and let it idle for
approximately 10 seconds.
Check the condition of the fault
code using the malfunction
mode of the Yamaha diagnostic
tool.
Condition is "Recovered"  Go
to item 8 and finish the service.
Condition is "Detected"  Go to
item 2.
Also, delete this fault code,
which has a condition of
"Detected".
Start the engine and let it idle for
approximately 10 seconds.
Check the condition of the fault
code using the malfunction
mode of the Yamaha diagnostic
tool.
Condition is "Recovered"  Go
to item 8 and finish the service.
Condition is "Detected"  Go to
item 3.
Also, delete this fault code,
which has a condition of
"Detected".
Start the engine and let it idle for
approximately 10 seconds.
Check the condition of the fault
code using the malfunction
mode of the Yamaha diagnostic
tool.
Condition is "Recovered"  Go
to item 8 and finish the service.
Condition is "Detected"  Go to
item 4.
Also, delete this fault code,
which has a condition of
"Detected".