Yamaha TMAX XP530E-A 2017 Service Manual page 523

Fault code No.
Item
B-6 Wire harness continuity.
B-7 Defective cruise control setting
switch.
B-8 Malfunction in ECU.
B-9 Delete the fault code and check
that the engine trouble warning
light goes off.
CRUISE CONTROL SYSTEM (for XP530D-A)
P0564
Cruise control setting switch "RES+": open or short circuit is
A
detected.
Cruise control setting switch "SET–": open or short circuit is
B
detected.
Open or short circuit  Replace
the wire harness.
Between ignition system relay
coupler and fuse box.
brown/blue–brown/blue
Between fuse box and handle-
bar switch coupler (left).
red/white–yellow/black
Between handlebar switch cou-
pler (left) and ECU coupler.
green/blue–green/blue
Replace the handlebar switch
(left).
Replace the ECU.
Refer to "REPLACING THE
ECU (Engine Control Unit)" on
page 8-230.
Confirm that the fault code has
a condition of "Recovered"
using the Yamaha diagnostic
tool, and then delete the fault
code.
8-132
Push the ON/start switch.
Push and "SET–" side of the
cruise control setting switch,
and then check the condition of
the fault code using the mal-
function mode of the Yamaha
diagnostic tool.
Condition is "Recovered"  Go
to item B-9 and finish the ser-
vice.
Condition is "Detected"  Go to
item B-7.
Push the ON/start switch.
Push the "RES+" side and
"SET–" side of the cruise control
setting switch, and then check
the condition of the fault code
using the malfunction mode of
the Yamaha diagnostic tool.
Condition is "Recovered"  Go
to item B-9 and finish the ser-
vice.
Condition is "Detected"  Go to
item B-8.