Yamaha TMAX XP530E-A 2017 Service Manual page 111

1. Fuel tank breather hose (fuel tank to rollover
valve)
2. Fuel tank
3. Clamp
4. Rear brake hose (hydraulic unit to rear brake
caliper)
5. Fuel tank breather hose (rollover valve to
canister)
6. Coolant pipe
7. Canister purge hose (hose joint to canister)
8. Canister breather hose
9. Canister
10.Rollover valve
11.Clip
A. Install the fuel tank breather hose with the
mark facing the outside. Align the mark on
the hose with the back end of the clamp.
B. Fasten the rear brake hose and fuel tank
breather hose with the clamp. Install the
clamp with the longer side of the fixed section
facing downward, and adjust the position so
that the intersection of the rear brake hose
and fuel tank breather hose is in contact with
the clamp.
C. Install the clamp into the hole in the stay of
the coolant pipe. Fasten the canister purge
hose with the clamp.
D. For the hoses to be installed to the canister,
install the fuel tank breather hose on the out-
side and the canister purge hose on the
inside.
E. Install the fuel tank breather hose with the
mark facing the outside. The end of the fuel
tank breather hose should come into contact
with the rollover valve.
F. The end of the clip should face downward.
Make sure the clip does not ride on top of the
bulge in the hose installing area.
G. Route the fuel tank breather hose and canis-
ter purge hose on the inside of the guide sec-
tion of the bracket.
2-64
CABLE ROUTING