Throttle grip free play
1.0–3.0 mm (0.04–0.12 in)
4. Adjust:
• Throttle grip free play
TIP
Prior to adjusting the throttle grip free play, throt-
tle body synchronization should be adjusted
properly.
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Slide back the rubber cover "1".
b. Loosen the locknut "2".
c. Turn the adjusting nut "3" in direction "a" or "b"
until the specified throttle grip free play is ob-
tained.
Direction "a"
Throttle grip free play is increased.
Direction "b"
Throttle grip free play is decreased.
d. Tighten the locknut.
Throttle cable adjusting locknut
3.8 N·m (0.38 kgf·m, 2.8 lb·ft)
e. Slide the rubber cover to its original position.
TIP
Make sure that the adjusting nut is covered com-
pletely by the rubber cover.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
a
1
a
3
b
2
PERIODIC MAINTENANCE
EAS30816
CHECKING AND CHARGING THE BATTERY
Refer to "CHECKING AND CHARGING THE
BATTERY" on page 8-230.
EAS30662
CHECKING THE FUSES
Refer to "CHECKING THE FUSES" on page
8-229.
EAS30664
ADJUSTING THE HEADLIGHT BEAMS
1. Adjust:
• Headlight beam (vertically)
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Turn the adjusting screw "1" in direction "a" or
"b".
TIP
Other than the socket wrench, the adjusting
screws can be turned with a screwdriver (Phillips
No. 2) "2" as shown in the illustration.
Direction "a"
Headlight beam is raised.
Direction "b"
Headlight beam is lowered.
1
b
a
2
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
2. Adjust:
• Headlight beam (horizontally)
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Turn the adjusting screw "1" in direction "a" or
"b".
TIP
Other than the socket wrench, the adjusting
screws can be turned with a screwdriver (Phillips
No. 2) "2" as shown in the illustration.
Left headlight
Direction "a"
Headlight beam moves to the right.
Direction "b"
Headlight beam moves to the left.
3-34
1
a
2
a
b
2
1
b