Fault Code No. U0155 Or “Err” - Yamaha TMAX XP530E-A 2017 Service Manual

Fault code No. U0155 or "Err"
TIP
"Err" is displayed on the clock display of the multi-function meter, but the engine trouble warning light
does not come on.
Fault code No.
Item
Probable cause of malfunc-
Item
tion and check
1 Connection of meter assembly
coupler.
Check the locking condition of
the coupler.
Disconnect the coupler and
check the pins (bent or broken
terminals and locking condition
of the pins).
2 Connection of ECU coupler.
Check the locking condition of
the coupler.
Disconnect the coupler and
check the pins (bent or broken
terminals and locking condition
of the pins).
3 Wire harness continuity.
4 Defective meter assembly.
5 Malfunction in ECU.
6 Delete the fault code and check
that the engine trouble warning
light goes off.
U0155 or "Err"
Multi-function meter: signals cannot be transmitted between the
ECU and the multi-function meter.
Maintenance job
Improperly connected  Con-
nect the coupler securely or
replace the wire harness.
Improperly connected  Con-
nect the coupler securely or
replace the wire harness.
Open or short circuit  Replace
the wire harness.
Between meter assembly cou-
pler and joint coupler.
light green/blue–light green/blue
light green/white–light
green/white
Between joint coupler and ECU
coupler.
light green/blue–light green/blue
light green/white–light
green/white
Replace the meter assembly.
Replace the ECU.
Refer to "REPLACING THE
ECU (Engine Control Unit)" on
page 8-230.
Confirm that the fault code has
a condition of "Recovered"
using the Yamaha diagnostic
tool, and then delete the fault
code.
8-115
FUEL INJECTION SYSTEM
Confirmation of service com-
Push the ON/start switch, and
then check the condition of the
fault code using the malfunction
mode of the Yamaha diagnostic
tool.
Condition is "Recovered"  Go
to item 6 and finish the service.
Condition is "Detected"  Go to
item 2.
Push the ON/start switch, and
then check the condition of the
fault code using the malfunction
mode of the Yamaha diagnostic
tool.
Condition is "Recovered"  Go
to item 6 and finish the service.
Condition is "Detected"  Go to
item 3.
Push the ON/start switch, and
then check the condition of the
fault code using the malfunction
mode of the Yamaha diagnostic
tool.
Condition is "Recovered"  Go
to item 6 and finish the service.
Condition is "Detected"  Go to
item 4.
Push the ON/start switch, and
then check the condition of the
fault code using the malfunction
mode of the Yamaha diagnostic
tool.
Condition is "Recovered"  Go
to item 6 and finish the service.
Condition is "Detected"  Go to
item 5.
Service is finished.
pletion