Yamaha TMAX XP530E-A 2017 Service Manual page 93

1. Fuse box 4 (for XP530D-A)
2. Fuse box 5 (for XP530D-A)
3. Fuse box 2
4. Starter relay lead
5. Fuse box 1
6. Fuse box 3
7. ABS ECU coupler
8. Intake air pressure sensor
9. Lean angle sensor
10.Canister purge hose
11.Coolant temperature sensor
12.Coupler cover
13.Plastic locking tie
14.Meter assembly lead
15.Handlebar switch lead (left/right)/Grip warmer
lead (left/right) (for XP530D-A)/Front brake
light switch lead (for XP530D-A)/Rear brake
light switch lead (for XP530D-A)
16.Front brake hose (hydraulic unit to front brake
caliper)
17.Rear brake hose (rear brake master cylinder
to hydraulic unit)
18.Front brake hose (front brake master cylinder
to hydraulic unit)
19.Windshield drive unit cable
20.Fuel tank fitting bracket
21.Injector #2
22.Injector #1
23.Throttle servo motor lead
A. Route the coolant temperature sensor lead
below the canister purge hose.
B. Route the wire harness below the protruding
portion of the fuel tank bracket.
C. Install the clamp into the screw hole in the
bracket. (except for XP530E-A)
D. Install the clamp so that it touches the cou-
pler side within the range shown in the illus-
tration.
E. 0–10 mm (0–0.39 in)
F. Install the coupler cover so that the white
paint mark is on top.
G. Make sure the plastic locking tie does not
come into contact with the fuel tank.
H. After connecting the coupler to the meter,
insert it until the coupler cover contacts the
bottom of the meter.
I. Route the leads on the inside of the bracket.
J. Route these leads between the steel tube of
the front brake hose (hydraulic unit to front
brake caliper) and the headlight stay.
K. Route the wire harness between the lean
angle sensor and the fuel tank fitting bracket.
L. The end of the clamp should face the bottom
without being cut.
2-46
CABLE ROUTING