Replacing The Rear Brake Lock Pads - Yamaha TMAX XP530E-A 2017 Service Manual

LOWER
6. Check:
• Brake lever operation
Soft or spongy feeling  Bleed the brake sys-
tem.
Refer to "BLEEDING THE HYDRAULIC
BRAKE SYSTEM" on page 3-17.
EAS31417

REPLACING THE REAR BRAKE LOCK PADS

1. Remove:
• Rear brake lock cable adjusting nut "1"
• Pin "2"
• Rear brake lock spring "3"
1
2
2. Remove:
• Rear brake lock caliper bolts "1"
• Rear brake lock caliper "2"
2
1
3. Remove:
• Rear brake lock pad (left side) "1"
a
3
1
TIP
Push on the back of the pad using a rod with a
round end.
4. Remove:
• Rear brake lock pad (right side) "1"
▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼▼
a. Remove the bolt "2", and then slide the rear
brake lock caliper bracket "3".
2
b. Insert a flathead screwdriver in between the
piston adjusting bolt and rear brake lock pad
and then remove the rear brake lock pad.
ECA22110
NOTICE
Avoid scratching the dust seal on the side of
the piston adjusting bolt carefully.
4-67
REAR BRAKE
1
1
3