9. Check the starting circuit cut-off re-
lay.
Refer to "CHECKING THE RE-
LAYS" on page 8-233.
OK
10.Check the sidestand relay.
Refer to "CHECKING THE RE-
LAYS" on page 8-233.
OK
11.Check the sidestand switch.
Refer to "CHECKING THE
SWITCHES" on page 8-221.
OK
12.Check the engine stop switch.
Refer to "CHECKING THE
SWITCHES" on page 8-221.
OK
13.Check the lean angle sensor.
Refer to "CHECKING THE LEAN
ANGLE SENSOR" on page 8-242.
OK
14.Check the crankshaft position sen-
sor.
Refer to "CHECKING THE CRANK-
SHAFT POSITION SENSOR" on
page 8-242.
OK
15.Check the entire ignition system's
wiring.
Refer to "CIRCUIT DIAGRAM" on
page 8-1.
OK
Replace the ECU or remote control
unit.
Replace the starting circuit cut-off relay.
NG
Replace the sidestand relay.
NG
Replace the sidestand switch.
NG
The engine stop switch is faulty. Replace
the handlebar switch (right).
NG
Replace the lean angle sensor.
NG
Replace the stator coil.
NG
Properly connect or replace the wire har-
ness.
NG
8-8
IGNITION SYSTEM