Installing The Front Fork Legs - Yamaha TMAX XP530E-A 2017 Service Manual

5
f. Remove the rod puller and the rod puller at-
tachment.
g. Install the damper rod locknut "1" onto the
damper rod and turn it until it stops.
h. Install the cap bolt "4", and then tighten the
damper rod locknut "1" until it contacts the
bolt.
4
i. Hold the cap bolt and tighten the damper rod
locknut to specification.
Damper rod locknut
15 N·m (1.5 kgf·m, 11 lb·ft)
j. Remove the rod holder and fork spring com-
pressor.
▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲▲
EAS30210

INSTALLING THE FRONT FORK LEGS

The following procedure applies to both of the
front fork legs.
1. Install:
• Front fork leg
Temporarily tighten the upper and lower
6
1
3
1
1
4-95
bracket pinch bolts.
TIP
Make sure the outer tube is flush with the top of
the upper bracket.
2. Tighten:
• Lower bracket pinch bolts "1"
• Cap bolt "2"
• Upper bracket pinch bolt "3"
Lower bracket pinch bolt
23 N·m (2.3 kgf·m, 17 lb·ft)
Front fork cap bolt
23 N·m (2.3 kgf·m, 17 lb·ft)
Upper bracket pinch bolt
30 N·m (3.0 kgf·m, 22 lb·ft)
1
FRONT FORK
2
3