Yamaha TMAX XP530E-A 2017 Service Manual page 85

1. Tail/brake light lead (right)
2. Storage box light switch lead
3. Rear wheel sensor lead
4. Fuel pump lead
5. O sensor lead
2
6. Storage box light lead
7. Storage box
8. Starter motor lead
9. Rear brake lock cable
10.Brake hose
11.Wire harness
A. Install the white tape section of the wire har-
ness into the notch area of the storage box.
After the wire harness is connected to the
tail/brake light lead and storage box light
switch lead, it is allowed to be detached from
the notch area.
B. Route the fuel pump lead under the rear
frame.
C. Coupler for the battery charger (optional)
D. Install the clamp of the O
the hole of the V-belt case air filter case.
E. To seat lock key cylinder
F. To seat heater (for XP530D-A)
G. Fasten the lead with the clamp.
H. It does not matter whether the storage box
light leads are installed on the left or right of
the storage box light.
I. Install the clamp of the seat heater lead
against the rib of the storage box.
J. Rib of storage box
K. Around the starter motor
L. Push in the starter motor lead underneath the
air duct.
M. Install the clamp within the range shown in
the illustration.
N. Install the O sensor coupler to the rear brake
2
lock cable bracket.
O. Fully insert the clamp all the way to the back
of the rear frame rib.
P. Fasten the O sensor lead to the rib section
2
of the V-belt case air filter case.
sensor lead into
2
2-38
CABLE ROUTING