Table of Contents
Advertisement
SG 04.2
SG 10.2
with actuator controls MEC 03.1
Information
1.3.
Warnings and notes
1.4.
References and symbols
Information
Wiring diagram
Buried service
Continuous submersion (observe enclosure protection)
Potentially explosive atmospheres
Radiation exposed areas in nuclear power plants
No liability can be assumed for inappropriate or unintended use.
Observance of these operation instructions is considered as part of the device's
designated use.
These operation instructions are only valid for the "clockwise closing" standard
version, i.e. driven shaft turns clockwise to close the valve.
The following warnings draw special attention to safety-relevant procedures in these
operation instructions, each marked by the appropriate signal word (DANGER,
WARNING, CAUTION, NOTICE).
Indicates an imminently hazardous situation with a high level of risk. Failure
to observe this warning results in death or serious injury.
Indicates a potentially hazardous situation with a medium level of risk. Failure
to observe this warning could result in death or serious injury.
Indicates a potentially hazardous situation with a low level of risk. Failure to
observe this warning could result in minor or moderate injury. May also be
used with property damage.
Potentially hazardous situation. Failure to observe this warning could result
in property damage. Is not used for personal injury.
Safety alert symbol
The signal word (here: DANGER) indicates the level of hazard.
The following references and symbols are used in these instructions:
The term Information preceding the text indicates important notes and information.
Symbol for CLOSED (valve closed)
Symbol for OPEN (valve open)
Texts extracted from other documents
Texts extracted from other documents are highlighted in a different font. For example
.
Wiring diagram
Result of a process step
Describes the result of a preceding process step.
warns of a potential personal injury hazard.
Safety instructions
5
Advertisement
Table of Contents
