Operating Time: Set - AUMA SG Series Operation Instructions Manual

SG 04.2 SG 10.2
with actuator controls MEC 03.1
8.5.

Operating time: set

Figure 29: Switches for tripping torque
[S6] Tripping torque in direction OPEN
[S7] Tripping torque in direction CLOSE
Default value: depending on the order
Setting range: in 8 steps (refer to tables), linear from 40
tripping torque.
Table 9:
Switch steps
SG 04.2
0 25
1 25
2 30
3 35
4 40
5 45
6 50
7 55
8 63
9 63
Setting via software parameters (AUMA CDT)
Condition: Switch [S5] is in position ON (software mode).
Setting parameters
Customer settings
Torque switching
Tripping torque CLOSE (S7)
Tripping torque OPEN (S6)
Default value: depending on the order
Setting ranges: adjustable between 40
Operating time is defined by the motor speed.
Basic settings for the actuator controls
Tripping torques [Nm]
SG 05.2 SG 07.2
50 100
50 100
60 120
70 140
80 160
90 180
100 200
110 220
125 250
125 250
100 % of the maximum tripping torque
100 % of the maximum
SG 10.2
200
200
240
280
320
360
400
440
500
500
31